Basement walls are framed in 24 inch and fully insulated and vapor barrier. Would you frame in front on 16 center for electrical to be done?

11/26/2019 at 2:44:37 PM

Hi Mike,

Thanks for reaching out to Strongback Construction through trusted pros. You honestly can do either of what you are comfortable with. Although if it was me doing the job I would cut the drywall 4 feet high on your existing wall nicely cut and peel back the vapour barrier remove any insulation necessary to do your electrical work. Then reinstall the insulation repair your vapour barrier and because you cut the drywall 4 feet high you will be able to replace the drywall with ease.

This would save you all the unnecessary cost of building an additional wall that is not needed. Good luck and if you need a hand with the work or even an estimate you can get us at our website

http://strongbackconstruction.net/ or on Homestars where I already have reviews and galleries that you can browse.

Thanks and have a good day.

11/26/2019 at 2:57:34 PM

I would but I'm a custom Carpenter contractor. By code you can leave the 24 in framing has his for electrical Plumbing Etc hope this helps you.

11/26/2019 at 3:40:51 PM

While it certainly is advantageous to have your electrical on the warm side of the VP (no penetration points to allow moisture to escape) in my experience, everything hinges on how well that vapour barrier is installed. Depending on the condition and type of the existing insulation and vapour barrier, I would use this opportunity to inspect the insulation, potentially upgrade it to a mineral wool (like Roxall batting) and check the foundation for any cracks or mould. If I am going to finish a basement, I feel better knowing that everything behind the walls is up to par and functioning as it should.

I hope this helps!

11/27/2019 at 7:33:17 PM

I think that's unnecessary. I agree with what others here have recommended. Vapour barrier can easily be repaired. Just run your electrical and then put the insulation back, and repair the vapour barrier.