Categories
6/9/2019 at 8:33:04 AM
6/12/2019 at 11:45:15 AM
Trustedpros Inc. does not warrant the accuracy, completeness, safety, legality or usefulness of any Content, or Whether Content is Current and up-to-date, and TrustedPros Inc. Shall have no liability whatsoever with respect to your use or reliance upon any content or for content being removed or otherwise ceasing to be available. Please refer to the terms and conditions of use of this websites for more details.
What do builders typically use so that water does not penetrate where Siding and Half Brick Wall meets?
Posted by: Mark from Sharpsville
6/9/2019 at 8:33:04 AM
I am redoing an old sunroom that has a half brick wall on the bottom. I am going to use siding on the top, and there is a 3 inch gap between the osb board and brick where they meet. What do builders typically use so that water does not penetrate this area?
REPLIES (1)
Jeff from All-In Renovations in Calgary
6/12/2019 at 11:45:15 AM
Flashing is always used. It should go up the wall under the siding with a slight angle over and with a drip edge exceeding Over and down from the brick at least 1 in. This might need to be customized flashing with a break.
Search the TrustedPros directory and discover the best contractors in your area.
Find your home service pro
