Job includes:
-Upgrade from 15A to 20A and moving up/over x5
-upgrade from 15A to 20A, moving and GFCI x 1
-move 240 stove outlet
-provision for stove vent hood install
- addition of pendant lamp using existing bulkhead over sink
- removal if 2 ceiling fixtures and replace with dimmable LED pot lamps (quantity tbd)
Kitchen is a galley style with eat-in that we are converting to one large kitchen. Placement of panel is below kitchen and across basement by 25 ft max. Drywall would be removed in basement and kitchen to allow for ease of access ahead of time.
We also would require a review of the service based on the load. Current service appears to be 100A but service entering home to be confirmed.
This project is for a new kitchen installation in a brand new house. Here are the items I need done. The quote I need is for labour only, no supplies. Kitchen size is 12'4€ X 16'0€ (14'0€). Certified Electrician is preferred.
1) Install brand new built in Jenn-Air appliances including gas range, vent, dishwasher, fridge, microwave/oven combo, beverage center.
2) Install 8-10 pot lights in kitchen
3) Install Kitchen Cabinet lights (under cabinets and two pot lights in cabinets)
Licenced Electrician for foyer and landing light install
Need licenced electrician to install two lights. One in main foyer ceiling, and second on landing in ceiling. Scaffolding might be required.
Details:
Foyer ceiling height 18
Light weight & dimensions
35 lbs
21.5"w X 43.5"h
Landing ceiling height approx. 13
Light weight & dimensions
18 lbs
25w x 28h
Brampton area (Queen Street/James Potter). Work to commence after June 12th. Pictures are available.
Licensed Electrician Needed:
============================
We have removed 2 walls to open up a room to be open concept, and we need to have the old outlets, wall switches and ceiling wires, thermostat to be relocated.
Approximately:
- 3 oulets
- 2 wall swithes
- thermostate
- door bell
- ceiling wiring for light
Budget: $200 to $250
Looking for licensed electrician to do the following work in my house.
1) install small basebaord heater in washroom
2) replace 1 light switch
3) install motion sensor in garage
4) install light switch in garage
5) install light fixture
6) install 3 seperate doorbells
Please send me a estimated quote by hour or for entire job at which point I will promptly set up an appointment to do the work this week.
Thanks
I have just purchased a commercial unit and need to ensure that the electrical system meets the City of Brampton code requirements. I also need additional electrical outlets, light switches and lights. I need to know what is required if any in regards to additional panels for the power consumption needs of the office. Finally the whole system needs to be approved by a city of brampton inspector. There may also be the need for the installation of a fire alarm.
Raj N
Hello,
We moved into a used detached home and had a home inspection conducted. The home inspector indicated that we require a licensed electrician to repair our main electrical panel to make sure the below items are fixed to standard code:
1) grounding conductor is loose and requires repair
2) 3-double tapping noted at main electrical panel is a safety issue (3 photos attached)
3) Improperly sized fuses / breakers are presently used at main panel
4) 30 Amp breaker is oversized - Fire Hazard ( A / C ) (1 photo attached)
As such, I am looking for some quotes to perform the above work.
Thank you,
Vincent
Store is moving from Brampton to Mississauga location:
Remove 2 medium and 2 small chandeliers plus 6 vanity light wall fixtures.
Specifically on Monday August 4th anytime between 4pm and 8pm
Then on Saturday August 9th in Mississauga (Derry/Dixie) between 2pm and 5pm, hang chandeliers, vanity lights more or less.
Need someone for these exact dates that is friendly and flexible, easy to work with.
We require at least two or theee outlets installed in our unfinished basement to accommodate TV and four or five accessories.
We also require outlets in the unfinished basement for a home office set up including desktop computer, modem, router, printer/fax machine and several other accessories.
Additionally we would like to have a light switch installed to control the main light in the used part of the basement.
Lastly we would like to see if one or two additional outlets can be installed on the main floor living room.
Hi could you please give estimate on this job I need done
Will provide all the material
Replace 1 exaust fan
4 led pot lights under the boloney with timer
Instal a electric outlet in the boloney
Move 3 lights switch from inside the house to the out side of the house
Instal one timer switch to a light
Instal 6 led lights fixtures in the back yard
Instal 1 motion senser light
Replace 1 motion senser light
Instal 28 led pot lights on the exterior of the house with time
Looking for an estimate to get the following jobs done in a Brampton townhouse:
Remove ceiling fan and replace with a light fixture
Replace old switches with new switches, and old outlets with new outlets in all rooms
Install 6 wall mounted lights in various rooms and basement (including running the inside wiring)
Replace vanity light fixtures in 2 washrooms
We would like everything done in one day: 31 July.
Please provide a quote, flat rate or hourly? We will buy the lights and switches, just need instalation by a certfied electrician..
thanks!
Hello I would like you to come and give me a estimate , I would like to put in a sound proof door and close off stairway to basement apartment, I am home all day until 1:30pm or weekend I am also interested to have electrical 220 supplied to upstairs wash-room to install a stackable washer dryer. This has to be completed before end of summer.
Hi,
Looking to budget for some upcoming home reno's. My basement family room is approx. 325 square feet. Currently I have ceiling tiles and a couple of lighting fixtures. I would like to put in a new ceiling with pot lights or recessed lighting (I'm not sure what the difference is between the two).
I also want to install new carpeting and underlay which will be 325 square feet as well.
Hi,
I'll be closing my new house end of this month. I'm looking for following work to be done:
1- Washer / Dryer installation
2- Over the Range microwave installation
3- Dishwasher installation
4- CAC installation as well as suggestion on which brand of CAC should I put in? My house is 2300 sq ft so I'm assuming i'll need 2.5 ton AC. Please provide the SEER rating and brand name with price separate from labour cost. Also please provide the efficiency and warranty on compressor and parts
5- Garage door opener installation
6- Humidifier material and installation
I would like the contractor to clean up after him and take all the waste material. Reputable contractor will be preferred.
On the back wall of my house I have one outdoor light fixture on one side of the back door. I would like to get a second light fixture installed on the other side of the door so that there is a fixture on either side of the door for a more balanced look.
See attached picture. The second fixture is to be installed on the right side of the door.
I already have the fixture.
Please let me know the cost to install the fixture.
I am currently adding concrete walkways and a patio to my home. Digging will be starting today. I need an expert to come in and add wiring for one post light at the front of the home and one at the back before the construction starts. I need them to be connected to the main light switches as well. My main concern is budget .. please send me a rough estimate before I decide to call you, thanks.
just bought a 1400sqft home in peel village in brampton ON. Im looking to contract out the painting of this home kit,Lvrm/ dinning room, 3 bed rooms, dinning room and hall ways, the lvrm and dinning have a chair rail and lower wayne scotting that i want remove as well as a short wall that has tile mirrors on it. The home is 48 yrs old and its dated the floors have been covered for 25 yrs plus. ill remove the carpet and the nail track and you finish them, your looking a 3 bed rooms upper hall way stairs lower hall way and living room/ dinning room. PLEASE NOTE!!! home closes oct 29th 2010
I purchased a new home and would like to upgrade/change the panel to one 100 amp service panel The existing service has a combination of breaker panel and fuse panel. The house is in Brampton and I will move into this location mid November, could you give me a ballpark estimate for budgeting purposes?
I have 1700 sq House located at Vodden and Kennedy 30 years old house and want some one to change my fuse panel to breaker. Hydro meter is inside the house. Is the job done without relocating the meter outside or not?. What is the Hydro requirement. I need the job done with certificate and hydro permission.
**** CLOSED ****
CONTRACTOR HAS BEEN SIGNED.
I have a need for an experienced electrician/contractor to install pot lights with dimmer switches in a brand new home (10 months old). I would like to install 55 in total on the MAIN floor of a two floor home as follows:
- 13 Pot Lights in Family room
- 14 Pot lights in Kitchen
- 17 Pot Lights in Dining Room
- 6 Pot Lights In Library
- 5 Pot Lights In Main Hall
I would look to you to provide the pot lights to take advantange of contractor discounts and am looking for 4.5" diameter for all the lights, so your price should include materials and labour.
I will be selecting the vendor based on the lowest price. Assuming 10 lights installed per day - i'm assuming this should take no more than 2 weeks.
TO BE CONSIDERED, please provide an all inclusive quote for the entire job based on the information above. I will not return calls without this information.
Please note - given the volume of emails i've received in the past (up to 30 separate vendors), I will only be contacting those who provide the requested information, and are within my budget.
Thank you
Post your project and let top-rated pros compete to get your business. Compare bids, read real customer reviews and hire the best contractor the first time.
Click here to get started