I purchased an antique church pew (9 feet long approx) and I want to have this turned into a "corner pew" for a breakfast nook. I
I also recently purchased new wood countertops from Ikea for my kitchen, and I need someone to cut them to the specific size that I need. The two pieces measure approx 2 x 8, and need to be cut into four carefully measured pieces.
There is a small yard at my house which could be used to do the cutting in. I cannot transport the pew or countertops anywhere, I don't have a vehicle that would accomodate this.
I am looking to have this work done ASAP.
Thank you!!!
We live in East York (DVP/Don Mills South) and built our house and now we need some custom work done. We have a large bay window in the living room and require a custom made bench with cushion on top and storage underneath. Also, we have a foyer where a custom made bench will be required also.
Contractor has a large rear addition that will need to have some corrective work done, including some underpinning, masonry block foundation walls, footings and concrete work. Work to start within the week, must be experienced and qualified with all insurances, and paperwork and references.
Looking for a handyman who can built and install the following :
Carpentry - Need to have three simple wooden frames built (specific measurements) and have them installed from floor to ceiling to serve as room dividers ( look like sohji screens ).
Electrical - Need to wire and install two wall sconces and also extend current wiring/cabe to a different wall location.
Price and quality are important.
Thank you
I would like to get carpentry work done at my house; the work involves the installation of Kitchen cabinets and drawers from Ikea, installation of drawers and others (from Ikea) in the five closets (3'x7', 3'x5', 2'x2', 2'x2', 3'x2', 5'x2'), and framing for the Kitchen countertop and island.
Hi I have 3 standard bedroom closets (one with french doors, 2 with pocket sliding doors). I would like to have them cut out and insert Ikea PAX closets in the space and have the walls closed around them. The closet dimensions are as follows: 44w x 18d, 43w x 18d, and 46w x 18d...and ceilings are 10 feet high throughout.
We are a busy commercial project management / general contracting firm. Seeking a wide variety of sub trades to bid on projects. Primarily - Demolition - Concrete forming / under pinning / concrete slab work.
We are open to new trades for new projects.. must have WSIB and Health and Safety Tickets primarily Working At Heights / WHIMS.
Carpenters,
Millwork Installers
Drywall framers installers
Tapers
Painters
Flooring - commercial carpet / engineered flooring
I'm interested in having a bookcase unit for my home.
Depending on its costs, I am also interested in having a rolling ladder, though a step ladder might also do.
The approximate dimensions for the bookcase are:
Width: 60"
Depth: 16"
Height: 120"
Attached is a photo that should give you an idea of what I'm looking for.
Please let me know if this is possible.
Thanks in advance for your time and consideration!
Hi, I'm looking to get a quote for a custom wall unit similar to the photos you see here.
I've included a photo of the current space (blue walls w/ shelf) for you to get an idea of the space. You'll notice there is a vent that obstructs the wall in the far right corner (above the 2 clay busts). Ideally I would like to have corner shelving (see image) installed here as part of the floating shelf design of the wall unit.
In terms of material, I'm are open to suggestions and quotes based on various offerings.
My budget for build and installation is $1,200, please let me know if can offer options within this range.
I look forward to hearing from you.
Thanks,
Cassi
Hi
I'm looking to build a custom shoe rack / cubby to put in the hallway entrance of a loft in downtown Toronto. The hallway is very long and limits our ability to use it for anything else. The area in the hallway we can work with is about 52" wide, about 174" long and has 8 ft ceilings.
The idea around the rack/shelf itself is to create 3 separate parts. The 3 parts/sections would be joined together when placed on the floor in the hallway. The sections on the left and right respectively would be approximately 55€ Long x 11.5€ Wide x 24€ High. Within each of these sections, there would be 2 open faced shelves for shoe storage. On top of these 2 sections, we're looking for a seating cushion.
The middle section should be about 64€ Long x 11.5€ Wide x 36€ High. This section would have 3 shelves in total to hold shoes in the same open faced style. The top of this section would be used to hold keys, mail, change, etc - stuff that you typically through on the counter/ledge/table when you walk in to your place. So theoretically, there could be a slide out drawer OR the top could have small little sections to hold different things.
We are looking for style and functionality over price and time. Although price and time are still important, we ultimately want something that's going to look good and serve our needs.
I have mocked up a diagram already of what we're looking for which can be supplied upon request.
My semi-detached house in Toronto needs to have the front pillar on porch repaired as there are some cracks in the foundation. I have already obtained a permit for the work and an Engineer has completed the drawings for the work. Needs experienced contractor who can get this work done within the next month.
Hi there,
I am interested in a quote for installing a wood fence gate with basic wood materials. Will need a pole and attached to the side of my brick wall house as well as a door handle.
Measurements are approximately 6 feet wide and 7 feet tall.
I am looking for a similar style such as the below ->click here am located in Stouffville.
Thank you,
Looking the carpenter or crew to trim out a basement. 160lf of baseboards and shoemold. Install 5 doors jambs and casing. 5 basement window jamb and casing. Get back to me with rough estimate and availability. Ideally looking to start immediately. Note all doorsand jambs will have to be cut down for low ceiling height.
Our 2nd floor of our home needs to have trim work done in 3 bedrooms, along with baseboards. We also have 4 Closet doors that need new casings and the doors to be hung and have hardware installed. There is also 3 Bedroom doors and 1 bathroom door that also needs to be hung and new casings and new hardware installed. Also we have 3 large windows and 2 small windows that need new casing and new trim.
We would like to start on this project as soon as possible, so any inquires we receive, we would like to have an invoice/contract written out detailing the precise work to be done, as well as at least 2 references and some pictures.
We are taking estimates at the moment.
Ran out of time to do myself. Need to finish trim carpentry on two windows in baby's room. New baby coming imminently so fairly urgent. Need you to install stool which needs to be routed, window jambs, casing and apron. I have all lumber onsite. Need your tools, time and craftsmanship.
we are interested in receiving quotes for our foyer renovations. we'd like to remove the current floor, level it and lay down marble 12x12 tile. we need someone know nows how to work with marble and Nu Heat radiant products.
we also need a new stair case built or perhaps the old one touched up. we'd like to add a bullnose larger step at the base of the current stair case. new staircase should be dark hardwood. please contact me directly to set up an appointment.
many thanks,
ashfa
The stairs in this picture will be removed. Please include materials and labour in your quote. The stairs are on the south wall of the house. There are 3 aspects to the job:
1. Frame in the floor joists where the stairs are now. Lay sub-floor.
2. Frame in a door and cabinet door above at the east end of the area (top of stairs going forward).
3. Stick frame 5 recessed shelves under the stairs (proposed picture attached)
If you would be willing to take the stairs and all garbage after the job, please provide a quote to do this as well.
Thanks
I would like to have a new front walkway(concrete) from the front porch to the main sidewalk. I would also need 2 steps to take us down to sidewalk level. If possible I would also like a safety rail for the 2 steps. I am sure this would be above.
Thank you
Jessica
We are the property owners.
Need a general framing carpenter for some small jobs for now. Several larger jobs are needed down the road. For now:
Move 1 hardwood passage step up. I have 1 step and then a landing on the 2nd floor of the house. The step is almost sitting on the landing. Need to remove this and resecure.
7 foot section of 2 closets facing opposite rooms. Need to frame in one side and open it up on the other and install 2 36" bi-fold doors.
Remove and replace stairs with winding staircase. I have 1 step and then a landing. Both are at 10" and turn 90 degrees. Need to remove this, open the area up a bit wider and replace the 2 steps with 3 in a winding fashion.
Location is near College/Ossington. Would prefer the work started anytime between Thurs and the weekend.
Thanks
Scope of work:
1. Reflected ceiling plan
A. Add dropped ceiling with 6 led potlights, and install a chandelier.
B. Provide a dimmable switch for chandelier.
C. Construct ceiling with 25mm gypsum board and required metal
Bracing.
D. Install pendant at lounge area from existing junction box
Located nearby.
2. Millwork
A. Build a custom millwork bookshelf with closed panels to hide existing electrical panel location.
B. Install ethanol fireplace into millwork, fireplace to be provided by owner.
C. Stone (travertine) to be installed around fireplace size is 1545mm x1100mm.
D. Material of millwork will be solid wood painted.
3. Patching
A. Patching may be required in bedrooms (6 existing drill holes).
4. Existing lighting
A. Removal of 2 existing surface mounted lights.
B. Removal of 1 existing pendant.
C. Installation of 2 new surface lights in entrance area.
Post your project and let top-rated pros compete to get your business. Compare bids, read real customer reviews and hire the best contractor the first time.
Click here to get started