Ever wonder what you're neighbours are doing to improve their homes? Discover what other Whitby homeowners have planned for their Electrical projects by reading the details of their request for quotes below.
In total, TrustedPros has received 30 Electrical projects posted by homeowners in Whitby seeking the services of local Electricians. Total estimated value of these projects is $94,500.00 with a per project average of $3,150.00.
|City||#Projects||Total Value||Avg Budget|
Install new Microwave over stove (currently only a range hood, will need property plug in for Microwave)
Install 2 ceiling fans in two bedrooms main floor.
relocate dining room light fixture over dining room table and install new light fixture.
Basement; Install light fixture over vanity (bsmt washroom), install ceiling light fixture in bsmt washroom. (Wiring is in place)
Install two bedroom light fixtures in basement.
Install wall switch in basement storage area. (Light fixture is there but needs replacing, I have replacement)
Outside front door install motion light.
I had a small-medium sized fire in the basement of my duplex and unfortunately everything was gutted but 95% of the electrical wiring and studs are still left. There is no drywall up and its ready to for electrical. The current wiring is not damaged at all, there are some lines which have been cut because 2-3 walls with studs had to be removed - everything is else is still up and its in original position. There are some things I'd like to add:
1. 15 Pot lights throughout the basement. (Wiring for the single ceiling lights are all still there.) I can provide the potlights - boxes are not needed as I will use the home depot ones - 10 for $50)
2. 4-6 plugs need to be added. (A couple walls where taken down and electrical as well but the new ones could probably be joined with existing sockets nearby)
3. 4 three way switches. (One to control living room potlights from 2 locations, and one to control hall/stairway light from top & bottom of stairway)
4. Wiring for smoke alarm in basement is still there, need to add wiring for a carbon minoxide device in the basement, and new wiring for a smoke/CO device in the upstairs.
- The panel right now is a 220V
- Has to be done with permit, please dont msg me if you dont pull permits.
- I'd like to get an estimate to add another hydro meter as well (It is a legal duplex)
Please e-mail me so we can setup an appointment to get an exact quote for this job - but you get the idea. If you want to give me a rough estimate, please feel free to do so as well.
Looking for an electrician to wire and install pot lights in our basement. (Room is approximately 20 x 16 feet) Ceiling has been removed, so installation would be done before drywalling begins. Some inspection and clean up of some previous wiring will be needed. (once we took down the existing ceiling, there are some wires and light boxes that we don't believe are properly installed).
Looking for estimates, but quotes preferred. We are available to set up a visit.
We live in Whitby.
Hoping to start as soon as possible, once we have an idea about cost.
I am looking to have some basic electrical work done in my house. It is an older house with aluminum wiring, and I am looking to have 7 light fixtures installed (I have already purchased the fixtures, and they will be replacing existing fixtures). I am looking for a quote on adding a second wall light to the master bedroom. There is currently one light mounted on the wall, but I would like a second installed on a different wall to improve the light quality in the room. If you could provide me with a rough quote on these installations, I would be greatly appreciative.
I need the electrical done for a hot tub. I have the 50 amp GFCI to go on the outside of the house. Our basement is finished, but we have dropped ceilings, so wire could be easily carried through the ceiling. I do not have a 50 amp breaker for the electrical panel. The panel also looks full, but I have read that two 15 amps could buddy up in one slot, or a sub panel could be put in.
Take out dividing walls on the family room and dining room and kitchen with vents and electrical wiring to be rerouted . May need to remove posts (about 5 of them) or replaced with decorated columns on hallways.
size of dining room is 10 by 9 which has the dividing walls. Age of house is 12 yrs and about 1900 sq.feet.
I want to get your quote for the installation of the following appliances in the house. I need a licensed plumber, gas and electrician help.
1-Central Vaccum: Kenmore/MD 673AW- Rough In ducts and outlets-Installation kit is available.
2-Vent Hood: KXW9736YSS-KitchenAid 36" Wall-Mount 1200 CFM Canopy Hood, Commercial-Style (8 Inch duct outlet available, needs a reducer from 10 inches of the vent to 8 inches duct of the house outlet)
3- 2 Garage door Openers: Belt Chamberlain Model : HD720EVGC
4- Combined Walloven/Microwave: HBL8751UC-Bosch 800 Series 30"
5-Dishwasher: SHX7PT55UC-Bosch 800 Plus Series 24"
6-Apron Slide In Cooktop: Hookup of E36GC75PSS-Electrolux ICON 36'' Gas Slide-In Cooktop (Natural Gas line is available)
7-Samsung Dryer Side Vent Kit installation and connection to the dryer wall outlet
8-Install Water Supply line for the fridge (Basement ceiling is unfinished & the water supply line is plastic)
9-Hookup of 3 bidets in the toilets (to the cold water line)
I would like to get two fans installed (one in the bathroom, the other one in the powder room ; both Delta Breez(VFB25ADL;VFB25AC).
I need this on Saturday, July 21, in the morning.
I live in Whitby, South of Victoria St.
Could you please let me know if you can do it and how much do you charge.
Currently undergoing a whole home renovation. converting a semi-detached home into 2 units for future rental potential, however, currently 2 brothers and their families moving in. Permits from City in Place.
Looking to move the electrical panel to a new approved spot and upgrade it to 200 AMPS. Also looking to install new pot lights in basement and new wiring of outlets upstairs and downstairs. Will also need to install interconnected Smoke and CO alarms. Lastly, looking to have all wiring needed for 2 kitchens and 2 washers/dryers.
I want to upgrade my exiting 60 amp service to a 100 or 200 amp. The house will be rented out, upstairs and downstairs seperately.
I am thinking of doing 100 amp only because there won't be AC in the house, and there will only be one common area for laundry.
I am located in Whitby. What would it cost me to do this, and I would appreciate your honest opinion on if I need a 100 or 200 amp service.
Post your project and let top-rated pros compete to get your business. Compare bids, read real customer reviews and hire the best contractor the first time.Click here to get started