Hi,
We need to renovate the interior of commercial space, 3900 sqf. It's located in Vaughan. The space is open now with 2 small offices and a washroom. Height 12'. (See the attached Floor Plans Before). Please be advise that is only rough sketch. Need to remeasure the space.
We are seeking pros for these works:
- drawing architectural, structural, mechanical.
- apply for Building permit; HVAC permit; Plumbing permit from Vaughan City
- demolition of one and a half office.
- Build up 1 more guest washroom
- divide the area into many zones by 10' height walls. Each zone is around 300-400 sqf. No door, just the opening. No ceiling, just open space above.
- ductwork
- electrical wiring
- Painting
- Flooring
- fire system water sprinkle (additional to the existing system)
See the attached Floor Plans After.
Looking forward to your competitive quote.
Best regards,
Nicky
Just bought a 1955 bungalow and need to rewire the kitchen. House has aluminum wiring, most outlets ungrounded. Walls and ceiling are plaster and exterior walls are double brick without studding. Kitchen is approx. 150 sq. ft.
Scope:
* run new wiring to plug on west wall to isolate for fridge and install ground
* relocate switch on west wall ( from one side of door to other side of door)
* install 2 new split circuit duplex receptacles on north wall and remove presently installed receptacle
* install wiring for undercabinet task lighting on north wall
* install dishwasher outlet on east wall**
* install wiring for under cabinet task lighting on east wall**
* install wiring for range hood (island type)
* install wiring for range (gas type)
* install 1 new split circuit duplex receptacle on south wall
* install pot lights
** note east wall is exterior wall without studding.
Want to install; 1) a manual power transfer switch in my furnace room to allow manual transfer to power from outside portage Honda generator, 2) a NEMA L14-30P PB30 Power Inlet Box (or similar weather proof box) outside of house, 3) run a wire from transfer switch to power inlet box on outside of house (estimate 10 feet or less), 4) build a power cord to connect Honda generator to inlet box (weather tight connections) of suitable size (AWG) of 20 feet. I do NOT have the hardware (transfer switch, power inlet box, wires,...) but have identified suppliers online if I have do procure.
Property Owner.
Not a rush job, needs a surgery to identify materials needed, secure materials, installation.
Hello,
My name is Nicky.
My house is upgrading from bungalow to 2-stories house (2 separate units). We have removed all old wire, and I am looking for installation new whole electric rough-in with 2 separate board and 2 submeters.
Attached the PDF of draft of drawings where we need switch, plug outlet or light.
Please provide your quote.
Best regards,
Nicky
Hello,
We live in etobicoke and I am looking for a licensed electrician who is experienced with outdoor soffit pot lights to install 24 pot lights for us in our soffits. I already purchased the housing for the pot lights and the bulbs.
I need a estimate on labor including the electrical wire and other materials required. We need the work done ASAP.
Thank You
OPEN FOR BIDS - SATURDAY FEBRUARY 19TH 9AM to 10:30AM
Plumbing & Electrical work needed for full residential renovation.
Interior demo complete.
Walls open and ready for plumbing & electrical work.
PLUMBING
2 Kitchens
-requiring plumbing upgrades, installation of sinks, dishwashers, etc. for full suite of appliances.
-3 Bathrooms requiring plumbing upgrades, installation of tubs, sinks, toilets, etc., for a full suite of appliances.
ELECTRICAL
-Inspection of existing electrical required. Identify where upgrades are necessary, if any. Run new wiring, install switches & outlets for new appliances, lighting and systems.
1. Installation of 6 Globe Electric 4" LED Integrated Ultra Slim Recessed Lighting, 9 Watts, Energy Star, IC Rated, Dimmable, Wet Rated, Fixed Flood in hallway / stairs area and 3 lights in different rooms, total of 9 pot lights.
2. Installation of 8 Globe Electric 3" LED Integrated Ultra Slim Recessed Lighting 9 Watts, Energy Star, IC Rated, Dimmable, Wet Rated, Fixed Flood in den area.
3. Installation of wall 3 dimmers in two bedrooms and den
4. Project can take place and be implemented strictly on Friday, August 24, 2018
Hi,
I will be removing my ceiling in the next couple of days and would like to install potlights while the ceilings are not finished. So, i guess new construction potlights are possible to install (the ones which attach to the joists). I am planning to install 10-12 in the living/dining/hallway area on two switches with dimmers. I will also need 6 potlights in the kitchen on two switches, no dimmers. Joists are 2" x 8" . How much would it be for the total job and how much is it per potlight?
Thank you
We wish to replace two old fluorescent light fixtures with regular light fixtures in the laundry room and furnace room, both in the basement. In our bedroom we want to replace the current light fixture with a ceiling fan. Also, in in the workroom in the basement the main line use to run into an old work bench, instead we want a properly grounded outlet installed. We will be buying the fixtures and ceiling fan.
Post your project and let top-rated pros compete to get your business. Compare bids, read real customer reviews and hire the best contractor the first time.
Click here to get started