Area milled and the existing deteriorated asphalt removed to a depth of two (2) inches.
The existing stone based will be compacted.
Any soft or spongy area encountered during construction should be immediately evaluated for underdrain installation or for removal and replacement with suitable materials. It may be necessary to patch or remove excess asphalt.
A tack coat shall be applied to the entire surface .06 -1 gal/sq yd to guarantee proper
bonding.
Hot asphalt HL3 finished coarse asphalt will be installed with at least a 1.7 metric ton vibratory roller and /or vibratory plate where required.
The pavement thickness for the parking area should have a minimum of three (3) inches compacted on a properly prepared subgrade.
The subgrade should be compacted to a uniform density of 92 percent of the maximum
density.
The materials for the asphalt pavement should be chosen and work performed to assure a pleasing and attractive surface.
An asphaltic sealant coating must be applied to the asphalt in two coats. The asphalt sealant is to be applied on the joint of adjacent pavement of neighboring semi-detached unit.
NOTES:
(a) This subcontractor shall provide a competent foreman on site to supervise own work and to coordinate own work with work of other trades
(b) Work is to proceed in accordance with work schedules as provided by the General contractor's job site superintendent.
(c) This subcontractor will remove all waste material and rubbish generated by own work to a container provided on site by the Builder. Failure to comply will result in an automatic back charge. Subcontractor is responsible for any damage to curbs, hydrants, sidewalks or underground water keys, wires and pipes caused by negligence on the part of this subcontractor.
We have an existing two car wide driveway with city sidewalk running through. It is 15 years old. It has sunk at the garage floor lip. We want to have it built up and resurfaced or replaced and cement curbs and a small sidewalk installed. ASAP we are in mississauga. Britannia and Winston Churchill area
Stamped Concrete on the sides of the driveway.
Stamped Concrete pathway from the driveway to the front of the house and to the backyard
Required work to make the top of the porch match the stamped concrete
Resurface of Driveway with asphalt
Removal of some existing landscaping with the addition of some grass.
I am looking for someone to widen our driveway to allow me to park while my husband can drive his car out of the garage without having to move my car. It would only be a small project (approximately 140 square - pretty much the length and width of my car) and we just want to have it done, for now, with crushed limestone. Right now I am parking on the grass and it's just a mess! Please let me know if this is something you might be able to do.
We have a concrete driveway that is designed for 1 car & we have 2, since concrete is too expensive, we thought asphalt to widen driveway would be the best choice, BUT not sure re the cost of it.. The area we wish to do is 20 feet long by 5 feet wide, we know its not a big area but is sorely needed or if there is another method that would work yet not cost a fortune, we are interested in hearing about that too.
Thank you and hope to hear back shortly.
Post your project and let top-rated pros compete to get your business. Compare bids, read real customer reviews and hire the best contractor the first time.
Click here to get started